Yamato Scientific DN410H Constant Temperature Ovens - Manual (Page 24)

18
Programmed Operation Method
Selection of operation
menu
•
Press the MENU key and
select the programmed
operation.
Press the MENU key.
The operation menu lamp of the
PROGRAM blinks.
•
will appear on the
sub display and the execution
program number can be input.
Input of execution
program number
•
Press either the ▲ key or
the ▼ key to indicate an
desired program number on
the main display, and press
the ENTER key.
Press either the ▲ key or the ▼ key
several times.
The program number will appear on
the main display.
NOTE: If no programs have been set,
―――― is blinking.
See the Operating Instructions
for Programmable Controller
to set a new program.
Push the ENTER key.
•
will appear on the
sub display and the operation
start time can be input.
Input of time
•
Press either the ▲ key or
the ▼ key to blink your
desired operation start time
(or hour) on the main display,
and press the ENTER key.
Press either the ▲ key or the ▼ key
several times.
The desired set time will appear on
the main display.
Push the ENTER key.
• The standby lamp on the
operation monitor blinks.
(Operation is in STANDBY
MODE)
• The operation will start after
the set time is up.