Weidmuller PRO-H Series Power Supplies - Manual (Page 9)

Tel: (800) 849-9343
Fax: (804) 379-2593
[email protected]
www.weidmuller.com
Date: 28 September
2009
Issue: 1.0
Page
9
Connect J3 pin 2 (S-) to output
GND (-) through 1K00 resistor
J3
Fig. 3.1
Block diagram CP T SNT 70W 12V 6A, CP T SNT 90W 24V 3.8A, CP T SNT 90W 24V 3.8AN &
Block diagram CP T SNT 140W 12V 12A, CP T SNT 180W 24V 7.5A, CP T SNT 180W 48V 4A, CP T SNT 360W 24V 15A &
CP T SNT 360W 48V 7.5A
Block diagram CP T SNT 600W 24V 25A & CP T SNT 600W 48V 12.5A
To fix the power supply on DIN-rail
Remote ON/OFF function
Fig. 2.1 Fig. 2.2
To remove the power supply from DIN-rail
Fig. 2.3 Fig. 2.4
Fig. 1.1
Fig. 1.2
Fig. 1.3