Vigo VG06051 User Manual

Page 6

STUDS

FIG.2

MODEL VG06051

PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION

1. Remove the plastic layer from the base border (if needed). Do Not remove the plastic layer

off the plastic platform of the base.

2. Properly apply silicone to the wall and base joints.

Verify that the overall size of the shower door opening is appropriate for the shower enclosure.

Because of the hole locations on the structural rail, cutting the rail is strongly not advised (see
page 3 diagram).

IMPORTANT

Due to individual site variations, exact guidelines for every situation

cannot be supplied. The recommended framing and dimensional

requirements are shown for a typical application and may vary depending

on the site requirements.

To prevent damage to the finish, you should protect the shower cabin

bottom with a cardboard protector before beginning the installation.

Ensure that there is sufficient structural support behind the shower wall to
hold the weight of the shower door. If there is insufficient enough support,

then reinforce the shower walls with wooden studs prior to shower door

installation. [SEE FIG.2]

1. Arrange the glass panel to the preferred configuration (see

diagram on pg.5).

INSTALLATION STEPS

2. Install the seal strip (#18) to both sides of the side glass panel (#6). [SEE FIG.3] The

seal strip that is not against the wall needs to be cut below the structural rail. The
structural rail will install through the small notch on the side glass panel (#6). [SEE FIG.4]

3. Screw the glass support (#20) to the side glass panel using the hex key (supplied). Use

a washer on each side of the panel.

5. Place the structural rail (#16) inside the wall mount bracket (#1). [SEE FIG.4 & FIG.5]

6. Place the structural rail screw (#17) into the side glass panel and screw together with the

structural rail.

A. INSTALLING THE SIDE GLASS PANEL

4. Slide the door stoppers (#15) to the structural rail (#16) if they are not already there.
Make sure to place them on either side of the screw holes on the structural rail. [SEE
FIG.3A]

For ease of installation, place the door panel (#7) on the inside of the cabin before starting.

IMPORTANT