Vigo VG06051 - Manual (Page 11)

FIG. 12
9
7
4
7
19
19
THIS END MUST
LOOK INSIDE THE
SHOWER
19
7
FIG. 14
FIG. 13
5
6
MODEL VG06051
F. INSTALLING THE HANDLE
1. Unscrew the handle holders from the handle (#9).
2. Align the handle to its respective door position with
a plastic washer on each side of the door. [SEE
FIG.12]
3. Tighten the handle holders from the inside of the
shower cabin.
G. INSTALLING THE WATER SEAL STRIP
1. Place the seal strip (#19) to both ends of the door
and to the big front fixed panel. Start the seal
strip on the door right above the door guide. Cut
the flange off of the seal strips (#19) beneath the
structural rail and door stoppers to provide
clearance for the door to slide open and closed.
[SEE FIG.13]
H. APPLYING THE SILICONE
1. Apply silicone caulk along the wall and
floor of the shower enclosure interior. [SEE FIG.14]
2. Apply silicone caulk along the fixed panel and the threshold enclosure interior.
MODEL VG06051
11