Unisteer 8011900-01 Chevrolet C10 Power Rack & Pinion Kit 1960-72 - Manual (Page 5)

Page 5 656410
1960-1966 shaft kit only
1. Make a mark on the steering shaft 1” down from clamp on upper end of shaft
(located where the shaft comes out of the firewall).
2. Cut steering shaft on 1” mark and remove the lower part of the stock steering
shaft.
3. Install new intermediate shaft kit on the rack using the lower u-joint. Slide the
upper u-joint onto the exposed remaining column shaft. Slide the intermediate
shaft into the upper u-joint. Note: make sure end of existing steering shaft is flush
with inside of u-joint. Tighten set screw on u-joint against the shaft with the u-
joints phased 90 Degrees off one another.
4. With supplied drill bit, drill a hole thru the u-joint and shaft, using the pre drilled
hole as a pilot.