Unisteer 8011900-01 Chevrolet C10 Power Rack & Pinion Kit 1960-72 - Manual (Page 3)

Page 3 656410
1960-1972 Chevrolet C10 Rack and Pinion Installation
1. Raise car off ground. Remove the outer tie rod end cotter pins. Remove tie rod
nuts. Remove the idler arm mounting bolts off of the passenger side of the frame
by removing the thru bolts.
2. Remove the pinch bolt from the input shaft on the steering box. This will allow
for the gearbox to be completely removed after removing the three bolts holding it
to the frame.
3. Remove all stock steering linkage from the vehicle.