TruXedo TonneauTraX - Manual (Page 5)

Do not tie to the T-Release handle. Only
tie to the anchor loops.
Do not attach heavy or unstable objects
to TonneauTraX rails. Use the trucks
factory bed anchors for heavy items
that exceed the recommended load
rating of the cargo anchors. Failure
to do so could cause damage to your
truck box or personal injury.
CAUTION
!
STEP 13: Set tension during warmest part of day. With cover closed, release the sewn loop fastener on the cover from the hook strip in
the side rail from both sides near the cab. Check compression of both spring plungers against the front header per diagram. Roll cover
open and make adjustments. Close cover and re-check adjustment. Repeat until satisfactory tension has been achieved.
adjust HERE
with
flat screwdriver
side rail
front header
spring plunger
EVER-TITE™
AUTOMATIC
TENSION
CONTROL
• Spring plunger compensates for material expansion &
contraction caused by temperature changes.
• Check cover tension after installation, seasonally, and after
extreme temperature changes.
• For best performance, adjust tension regularly to protect
your cover against wind wear.
COVER TENSION ADJUSTMENT
spring plunger front header
NOTE: Adjust tension in small increments. Slight
adjustments will gain significant results.
COVER TOO LOOSE
ROTATE CLOCKWISE
CORRECT TENSION
DURING WARMEST
PART OF DAY
no less than 1/16”
CARGO ANCHOR INSTALLATION CONTINUED
Each individual anchor is rated at a working load limit of 250 pounds. The total
loading for all anchor locations combined shall not exceed 1000 pounds. Failure
to follow these instructions could cause damage to the pickup bed.
hook fastener strip
Working Load Limit
Cargo Anchors
TROUBLE SHOOTING
HEADER WILL NOT LATCH:
Check side rails to make sure they are level. See Step 3.
Make sure the header seal is not caught between side rail & header.
Check position of side rails on pickup box, they may be positioned too low. See Step 2.
Make sure cover has proper tension. See Step 12.
FABRIC COVER IS TOO TIGHT OR TOO LOOSE: See Step 12 to adjust tension.
SPRING PLUNGER PUSHING OVER OR UNDER FRONT HEADER:
Check position of header guides. See Step 5.
* VELCRO ® is a registered trademark of the Velcro ® companies.
Questions?
Call our friendly customer service
staff at TruXedo Toll Free:
1-877-878-9336
Mon - Fri 8 am - 5 pm CST