Thrush DSVE Series - Manual (Page 11)

Thrush Co.
Manual #9636-0550
3.1.7 Pressure Gauge Assembly
The pressure gauge is a visual representation of pressure level in the steam side of the
unit. A gauge cock and pigtail siphon is included. (Figure 3-8)
Figure 3-8 Pressure Gauge Assembly
3.1.8 Control Panel (Standard)
The standard Hot-Pak control panel is an electrical connection panel only. The circuit
breaker (located on the center of the panel) only shuts down the circulator pump. Wiring
and 120 Volt power to the panel should come from a properly sized breaker or fused
disconnect. Local and state codes apply. (Figure 3-9)
OFF
ON
SYSTEM
ON
CIRCULATOR PUMP
ON
HIGH TEMP
ALARM
Figure 3-9 Control Panel (Standard)