Pressure relief procedure, Power module removal – TapeTech CTPMP Bazooka Continuous Flow Pump Repair User Manual
Page 4
Pressure Relief Procedure
4
3A0912A
Pressure Relief
Procedure
1.
Turn flow control knob to fully counterclockwise.
2.
Place deflector in hopper or suitable container.
3.
Turn prime valve handle to PRESSURE RELIEF
position.
4.
Display will read “----” when all pressure is relieved.
Power Module Removal
1.
Perform Pressure Relief Procedure. Unplug power
cord.
2.
Release hopper adapter clamp (158).
3.
Loosen rod clamp knob (112) on front of pump mod-
ule and push rod down.
4.
Lift and pull power module (153) off of unit.
NOTE: Power module weighs approximately 85 lb.
5.
Install hopper plug (117) if needed.
ti8793a
ti14876a
bar/psi
ti15614a
ti15684a
158
ti11675a
112
ti15623a
153
ti15623a
117