Talos Security DR800 Series DVR User Manual - Manual (Page 16)

H.264 Network DVR
- 16 -
3.1.2 Power on
If the power indicator LED is not illuminated, follow these steps:
1) Confirm that the power supply is connected to a functioning electrical outlet and connected to the DVR.
2) Switch the MAIN power switch on the rear of the DVR to the ON position.
If the power indicator LED is illuminated (red), press the POWER key to start the DVR.
Upon starting, the DVR video output defaults to multi-screen output mode
Click the right mouse button at the soft keyboard to close the
soft keyboard
Click the right mouse button at any place except the label, edit
box and buttons, to close the current window
Double-click any item in the recording list to play the file
Double-click the left mouse button to enlarge the video window
to full-screen or restore it to multi-screen
3 Left double-click
In PTZ control mode, double-click the left mouse button at the
center of the screen to enlarge the screen or restore it to
multi-screen
Adjust the numbers
Flip list box up and down
4 wheel
Control the lens zoom in the PTZ operation mode
Hold down the left mouse button in any screen position and
drag to the lower right corner to select the motion detection
area; hold down the right mouse button and drag to the lower
right corner to cancel the selected area
5 Mouse drag
Drag the play progress bar forward or backward to adjust the
location of the current record display; drag the slider forward or
backward to adjust the parameter