Sensaphone fgd-W610-B WEB600 Battery Backup - Manual (Page 2)

replacing the Battery
The battery can be replaced by following the instructions listed below. Replace ONLY with a rechargeable
6V 1.3AH sealed lead-acid battery. Replacement batteries are available from Sensaphone. Be sure to follow
the instructions in order as listed:
1) Disconnect the Battery Backup module cable from the WEB600.
2) Remove the four screws on the top cover.
3) Remove the battery from the enclosure and disconnect the wires from the battery.
4) Attached the red & black wires to the new battery connecting the red wire to the positive terminal
and the black wire to the negative terminal.
5) Place the battery inside the enclosure.
6) Re-install the cover and four screws.
7) Reconnect the cable to the WEB600.
SENSAPHONE
®
REMOTE MONITORING SOLUTIONS
901 Tryens Road • Aston, PA 19014 • PH: 610-558-2700 • ww.sensaphone.com