Sensaphone fgd-0100 REMOTE TEMPERATURE SENSOR - Manual

The Remote Temperature Sensor enables your
Sensaphone to measure the temperature at a location
away from the unit. This sensor is intended for
installation in a clean, dry environment. The Remote
Temperature Sensor can be used with the models
listed below.
Sensaphone Models: 400, 800, 1400, 1800, 2800,
CELL682, WEB600,
The sensor may be connected to any available
input terminal. Refer to your user’s manual for
configuration and programming.
To connect the sensor:
1. Remove any existing wiring or sensors
(including local thermistor) from the input terminal.
2. Attach two-conductor wire to the input terminal
and ground.
3. Connect the wires to the two screw terminals on
the remote temperature sensor.
4. Put the enclosure cover in place and install the
sensor housing securely using the two mounting
screws furnished.
5. See your Sensaphone user manual for
programming instructions.
REMOTE TEMPERATURE SENSOR
FGD-0100
V.1.52