Brother HL-1060 - Manual (Page 45)

III-6
(5) After removing the sector gear, paper feed bearing, and bearing 6, take off the
paper pick-up roller unit.
Fig. 3.7
(6) Raise the pressure plate toward you and press both sides of the pad inward to
release it by pressing the separation pad holder. Then take off the spring.
Note: If it is impossible to release the pressure plate in the above way, press the side of
the pressure plate (
) while pulling the side of the sheet feeder ( ).
Fig. 3.8
Note: Be sure to replace the regist sensor actuator film together whenever replacing
the regist sensor actuator.
Bearing 6
Paper feed
bearing
Sector gear
Paper pick-up
roller unit
Separation pad
Pressure plate
Spring
Separation pad holder
PR98062