RKI Instruments 71-0191RK - Manual (Page 11)

Connecting an Eagle 2 to the Maintenance Data Loader Program • 8
Connecting an Eagle 2 to
the Maintenance Data
Loader Program
Follow these steps to connect an Eagle 2 to the Maintenance Data
Loader Program:
1. Launch the Eagle 2 Maintenance Data Loader Program as
described in “Launching the Program” on page 7. The Main
Window displays.
2. Place the Eagle 2 within an inch or two of the infrared port on your
computer aligning the infrared port on the front of the Eagle 2 with
the infrared port on your computer.
If your computer does not have a built in infrared port, place the
Eagle 2 within an inch or two of the infrared port on the IrDA
adapter cable as shown in Figure 5 below, aligning the infrared
port on the front of the Eagle 2 with the infrared port on the cable.
Figure 4: The Main Window