Retsch TWISTER - Manual (Page 22)

Operating the machine
22
5.9 Setting the Speed
Pos : 7. 26 /00010 Bedi enungsanleit ung en Kapitels ammlungen/T wis ter Mill ( 2011) /0015 Z yklon Mill T wis ter Bedi enung/ 1535 N IR Modul Drehz ahl ei nst ellen @ 3 \ mod_1284536119309_9. doc @ 23350 @ @ 1
The speed can be set to three preset speeds.
• Press the LOW button (K2) for a speed of the rotor of 10000 revolutions per
minute.
• Press the MID button (K3) for a speed of the rotor of 12000 revolutions per
minute.
• Press the HIGH button (K4) for a speed of the rotor of 14000 revolutions per
minute.
Fig. 11: Setting the speed
LOW – 10000 revolutions per minute
HIGH – 12000 revolutions per minute
MID – 14000 revolutions per minute
Pos : 7. 27 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Mahl vorgang s tart en @ 0 \ mod_1227185008190_9. doc @ 3861 @ @ 1
5.10 Starting the grinding process
Pos : 7. 28 /00010 Bedi enungsanleit ung en Kapitels ammlungen/T wis ter Mill ( 2011) /0015 Z yklon Mill T wis ter Bedi enung/ 1545 N IR Modul Start der Ver mahl ung @ 3\ mod_1284536120403_9.doc @ 23368 @ @ 1
Fig. 12: Starting the device
Press the START button to begin grinding at the default speed.
NOTICE
The lid of the grinding chamber (L) must be placed on before closing the grinding
chamber hood. The device gets blocked when started without lid and the rotor can
get damaged.
K2
K4
K3