Retsch SR 200 - Manual (Page 9)

2/8/2012

Retsch GmbH
9
0002
Transport and setting up
Target group: Operators, Forwarders, Users
Packing
The packing is adjusted to the transport route. It complies with
the generally applicable packing regulations.
Please keep the packing for the whole of the guarantee period. If,
in the case of a complaint, the unit is returned in inadequate
packing, your guarantee rights may be jeopardised.
Fig.1
Transport
To transport the SR 200 use the ring bolt H. Fig.1
The SR 200 may not be subjected to shocks, shaken or thrown
during transport. Otherwise the electrical and mechanical
components may be damaged.
Temperature fluctuations
In the case of major temperature fluctuations (e.g. with
transportation by air), the SR 200 must be protected against
condensation. Otherwise the electrical components may be
damaged.
Intermediate storage
Ensure that the SR 200 is also kept dry when subject to
intermediate storage.
Parameters for setting-up location
Ambient temperature
The ambient temperature should be between 5°C and 40°C.
When the ambient temperature exceeds or falls below that specified,
the electronic and mechanical components may be damaged, and
performance data changed to an unknown extent.
Relative humidity
Maximum relative humidity 80 % at temperatures of 31°C, falling in a
linear fashion to 50 % relative humidity at 40°C.
At higher humidity, the electronic and mechanical components may
be damaged, and performance data changed to an unknown extent.
Setting-up altitude
max. 2000 m above sea level
Setting up with underframe