Retsch SR 200 - Manual (Page 15)

2/8/2012

Retsch GmbH
15
0002
Insert grinding insert 180° with frame and sieve insert
Fig.8
A selection of grinding inserts with frames and sieve inserts of
stainless steel with Conidur or round perforations are available as
accessories. Fig.8
Conidur 0.08/0.12/0.20/0.25/0.50/
0.75/1.0/1.25/1.5/2.0mm
Round hole 3.0/4.0/5.0/6.0/8.0/10.0mm
* Undo screws S2
* Remove ring R1 and insert sieve SI in the groove NU of the
ring R2
* Carefully mount the ring R1 until the sieve SI slides in the
groove NU
* Turn in screws S2 and tighten well
* Open door
* Insert sieve frame with ring sieve, ring R1 is to the front and
ring R2 to the rear
* Insert sieve frame with ring sieve, ring R1 is to the front and
ring R2 to the rear
* Screw heads S3 on the ring R2 belong to the holes of the mill
housing
* Close door
Ensure that a collecting pan is mounted.
*
Start the SR 200
Start or stop the SR 200
0 I
Fig.9
The SR 200 is started or stopped at the power switch A or A1.
Fig.9
* Insert sieve frame or grinding insert
* Close door
* Mount collecting pan
Start
* Press button  “I“ on switch A or turn knob on switch A1
to  “ON“
Stop
* Press button “0“ on switch A or turn knob on switch A1
 “OFF“