Retsch SR 200 User Manual
Page 17
2/8/2012
Retsch GmbH
17
0002
Assembly of feed device
When feeding larger quantities, it is advisable in general to feed
the material to be crushed evenly using a feed device. This
largely prevents any unnecessary load on the grinding tools and
reduces possible friction heat. An appropriate means of ensuring
even material feed is use of the feed device of the type DR
100/75, which is available as an accessory.
Fig.15
Fig.12
Fig.13
Fig. 14
Fig.15
Prepare the DR 100/75 for feed operation in accordance with its
operating instructions.
Assembly :
* Undo ring screw H,
Fig.12
* Turn in bolts BO,
Fig.13
* Push on fixture HA with tommy screw,
Fig. 14
* Tighten tommy screw
* Mount DR 100/75 and align
* Fasten with the two hexagon-head screws SC
M6x20 DIN933,
Fig. 14
* Insert power cable of the DR 100/75 in a socket with
earthing
* You will find the voltage and frequency of the DR100/75 on
the nameplate
If the values on the nameplate are not observed, electronic and
mechanical components may be damaged.