Retsch SM 200 - Manual (Page 28)

Mode of Operation of Feed Hopper
28
Pos : 10.1 /00005 Ü berschrif ten/ 1. Ü berschrif ten/ 1 Anwendungsbereic he der Tric ht er @ 1\ mod_1241512297333_9. doc @ 8940 @ @ 1
6 Mode of Operation of Feed Hopper
Pos : 10.2 /00004 Warnhinweis e/H 0013 HIN WEIS Motor bloc kade Zer kl einerungsgut bl oc ki ert R ot or @ 2\ mod_1259138832056_9. doc @ 17630 @ @ 1
NOTE
Motor blockage
The material being ground clogs the rotor
– Blockages can damage mechanical components.
• Feed material only while the device is running.
• Dose the material feed to suit the properties of the material.
Pos : 10.3 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ SM200/ 0025 SM 200 Anwendungsbereic he der Tric ht er/2505 SM 200 M odul Ei nfülltric ht er Bedienung @ 3\ mod_1280232856549_9. doc @ 22196 @ @ 1
• Turn on the device.
• Pull the metering plunger (C) and the plunger (B) upwards.
• Put the material to be ground into the filling hole(AE).
• If necessary, use the metering plunger to push the material to be ground in
further.
• Seize the plunger by the grip and pull the detent pin (D) .
• Press the plunger downwards slowly.
NOTE
Do not use excessive force on the plunger. Blockages can damage mechanical
components.
In most cases, the plunger’s own weight is sufficient to press the material to be
ground into the grinding chamber.
If not, press the plunger to push the material in further, gently and in accordance
with
the device’s capacity.
Pos : 11 / 00010 Bedi enungsanleit ungen Kapitels ammlungen/------- Seit enumbruc h ----------- @ 0\ mod_1222344373758_0.doc @ 2386 @ @ 1