MacDon 872 Combine Adapter - Manual (Page 30)

30
ASSEMBLY
INSTALL 962 HEADER COMPLETION PARTS
NOTE: This page applies to Model 962 Header only.
1. Deck backsheet extensions (C) and (D) are in the
Header Completion package that came with the
Combine Adapter. These are installed at the
delivery opening.
Install extension (C) on left side of delivery
opening and (D) on right side. Extensions mount
to rear of deck backsheet with 3/8 x 3/4 bolts and
flange locknuts. Install hardware with bolt heads
on draper side.
2. Retainers (E) are shipped with the Combine
Adapter. These are installed inside header
center legs to secure header to adapter when
full float is reached. Retainers also restrict
side movement.
Install retainer (E) at inside of left center leg,
using existing 0.41 x 0.81" slot. Secure with
3/8 x 3/4 carriage bolt (F) and flange locknut
(G). When tightening, ensure that header pin
fits freely through leg and retainer at (X).
NOTE: L/H leg is shown. Retainer (E) mounts
to leg side wall closest to center delivery
opening. Left and right retainers (E) are
different. Be sure they are correctly
positioned.
Repeat at right center leg.
3. For delivery openings of 41.7” (1060 mm) and
smaller, install draper supports (A) at cutterbar
side of idler roller bars using 3/8 x ¾ carriage head
bolts and flange nuts.
For larger openings, remove supports (A), if
installed.
A