MacDon 974 FlexDraper - Manual (Page 85)

Form # 147083 Issue 01/07 83
UNLOADING & ASSEMBLY
INSTALL DRAPERS
To install:
1. Use this chart to position connector tubes at the appropriate rows of holes for desired opening size.
NOTE: Recommended starting point is with decks shifted in, column (Y) for rows I and III.
For row II start at 45.4” (1155 mm) for specialty crops and 42.1” (1070 mm) or less for cereal crops.
2. Idler rollers are shipped in the mid range opening position. If row of holes (A – narrow deck) or (D) – wide
deck) is selected, the idler roller assembly must be repositioned in the decks. See "Idler Roller Positioning"
in Maintenance/Service section of Operator's Manual.
CENTER DELIVERY
OPENING WIDTH
(between rollers)
HEADER AND
COMBINE MODELS
CONNECTION
(both drapers)
With decks
shifted out
(W)
With decks
shifted in (Y)
LEG TO
IDLER ROLLER
EDGE (DIM. X)
(decks in)
ENDPANEL DEFLECTORS
(shown on page 27)
Row D to Row F
63.7”
(1620 mm)
53.5”
(1360 mm)
11”
(280 mm)
Standard
I
John Deere, New
Holland CX, Lexion
(Wide Decks)
Row B to Row E
49.8”
(1265 mm)
45.9”
(1165 mm)
16.8”
(427 mm)
Narrow
Row B to Row E
49.8”
(1265 mm)
39.6”
(1005 mm)
20”
(507 mm)
Standard
II
Case 77, 80 & 88
Case AFX, New
Holland CR
970/980, Lexion
(Mid Size Decks)
Row A to Row F
45.9”
(1165 mm)
42”
(1065 mm)
18.8”
(477 mm)
Narrow
III
Case 60 & 66,
Agco, New Holland
CR 920/940/960
Row A to Row F
45.9”
(1165 mm)
35.6”
(905 mm)
20”
(508 mm)
Standard
DELIVERY
OPENING
W
X
Y
A C D E F B