PIAA Deno 6 Daytime Running Lamp - Manual (Page 7)

-7-
PLI-1165
1
2
3
【4】Lamp Installation Procedures
Temporarily set the bracket with masking tape
and then mark the correct position.
Lamp Harness
Bracket
Masking Tape
Remove the lamp harness bullet correctr and take out the lamp.
Install the lamp according to the marking made prior to installation.
◆ If using only the double-side tape.
Peel the protective sheet from the double-sided tape (Item 3) and apply.
● When using the double-side adhesive tape, clean the surface where tape will be applied. Use a clean cloth or
sponge and make sure dirt, grease, wax etc., are completely removed. If substances cannot be removed, it
may not adhere properly. In particular, avoid using leather wax, tire wax and also any type of organic solvent.
● When used in low temperatures, the adhesive substance tends to lose its strength. Use a drier or simply
warm up the adhesive surface before applying. When using a drier, avoid moving it too close to the bumper
as it may cause it to deform.
● After installation, avoid excess speeds and do not wash for 1 to 2 days.
● If applied incorrectly, a special double-sided adhesive tape is available at your local PIAA dealer.
◆ If screws are used.
(1) Loosen the hexagon bolt with the
wrench(ltem 7) provided and remove
the bracket from the lamp.
(2) Peel off the protective sheet from the
double-sided tape and apply it to the
bracket.
(3) Fix the bracket in place with the
screws(item 4).
(4) Install the lamp onto the bracket.
Double-sided tape (Item 3)
Bracket
Hexagon bolt
Hexagon wrench
(Item 8)
Screw (Item 4)
Lamp body
protective sheet
bullet correctr