PIAA Deno 6 Daytime Running Lamp - Manual (Page 6)

-6-
PLI-1165
5
6
1 7
3
4
2
Connect a ring terminal to the lamp
harness.
Connect the spade terminal attached
to the tip of the black cord (ltem ⑧ )
Then ground it by attaching it to the
battery terminal or the vehicle ' s ground
point. (Make sure to properly ground it)
※ Wiring method allowing LED lamp to dim when the
headlights are turned on.
Use the one-touch connector that
comes with this product and connect
both the red and black cord according
to the figure below.
Red cord
Connect to cord linked to the
air-conditioner and power windows,
both of which power on when engine
in turned on.
White/Black Cord
Connect to Vehicle's light.
Spade terminal ⑧
（1 pcs.）
The numbers shown in the figure below indicate the sequence the parts should be installed.
Remove the (-)
terminal from the
battery. Attach the (-)
terminal to the
battery
Relay unit
Black cord
Red cord
White/Black cord
cord
One-touch connector
※ Use a pair of pliers to verify the
one-touch connector is secure.
Harness
Wire tie
After lamp has been installed, verify the harness does not make
contact with the engine s moving parts or sections that emit
extreme heat. Use the wire tie included (Item 6) and secure to
harnesses inside engine compartment.
【3】Wiring order for LED dim
Make sure to prop-
erly secure the
relay unit using
bolts or a harness.
The harness must
also be facing
downward.
※ After completing the above-mentioned work procedures, go to 【4】 Lamp installation procedures.