PIAA 570 Series L.E.D. - Manual (Page 6)

-6-
PKI-0017-2
When using the lamp for extended periods of time, we recommend that a lamp cover be used over the main
lamp unit in order to prevent undue damage.
LED
2
1 3
Lamp main unit
Lamp cover
【3】Procedures for Installing / Removing the lamp cover
For installing the lamp cover, fi rst take the small tab on the upper edge of the cover and line it up with the
slot on lamp unit and snap it in place. Then continue to snap the remaining tabs in place.
For removing the lamp cover shown in fi gure 1.2 below, take one tab on the lamp cover and lift it over the
slot on the lamp unit, then continue with the remaining 3 tabs.
● The lamp cover is structurally built so that it does not come loose while the vehicle is in
motion. Therefore, be extremely careful when removing and installing the lamp cover as
it is a very tight fi t.
installation
slots
The installation slots are located
at 4 positions on the lamp unit;
left / right and top / bottom.
Tabs
The installation tabs are located
at 4 positions on the lamp cov-
er; left / right and top /bottom.
View of lamp unit
from above. T h e i n s t a l l a t i o n
slots on the lamp
unit.
Tabs
Tabs
Tabs
Lamp
cover
installation
slots