PIAA 570 Series L.E.D. - Manual (Page 4)

-4-
PKI-0017-2
• When using a commercially supplied lamp bracket, before removing the bolt that is already
installed on the car body, make sure that it is safe to do so.
• The lamp should be mounted in an area sufficient to support its size and weight.
Failure to do so may result in excess vibration leading to shorter bulb life and or physical
damage to the lamp or your vehicle.
• Do not attempt to install the lamp directly to any plastic part of the car body.
If the lamp needs to be installed on the plastic reinforcement materials should be placed on
both sides of the plastic part.
• When installing, make sure the lamp body, lens and rim are not touching the bumper and other
plastic parts. Such plastic parts might deform.
• The lamp installation surface should be flat.
●ランプを市販のテープや両面テープ等で仮止めしてください。
● The lamp should be tightened to the degree that the lamp body cannot be moved by hand.
Flat washer
Nut
For lamp installation, a hole with a diameter
of 12mm is required. Make necessary preparation
such as installation of lamp bracket.
Flat washer
Nut
【1】Lamp installation
Tightening torque：30N-m
Orientation of logo
Spring washer
Spring washer
Rubber cushion
Rubber cushion