Paxton OEM Reader keypad kit - Manual (Page 3)

Page 3
Step 1: Mark the mounting points for the power supply. Drill the four holes, fit the wall plugs and
screw the power supply to the wall.
Step 3: Using the guides provided, make a gap for the cables on the power supply cover. Fit the cover,
feeding the cables through the gap. Do not connect the power supply to the mains until the lock is fitted.
Once this is done, power the system up, and start programming the system.
Step 2: Run the black cable from the reader to the power supply. Attach the white striped wire to the
12V power supply terminal, and the plain black wire to the 0V power supply terminal. The cables can be
secured in place using the cable clips provided. Please ensure that the cable is not damaged when fitting
the cable clips. Connect the power lead provided.
Fitting the power supply
Step 1: Carefully mark out the mounting holes for the keypad and the hole of the cable feed.
Step 2: Drill the marked holes for the mounting points and the cable feed. When drilling the holes, ensure
that you are aware of any hidden cables or pipes. Once the holes have been drilled, fit the supplied wall
plugs and feed the cable through the cable feed hole before securing the reader to the wall using the
screws supplied.
Step 3: Fit the keypad to the mounting plate and secure using the screw provided.
Fitting the keypad
Indoor use only