Paxton Swipe card 25 kit - Manual (Page 6)

-20 °C +55 °C
3 metres
IPX7
1,000,000
11V DC 14V DC
90 mA 100 mA
1 A
300 Oe 4000 Oe Lo-Co & Hi-Co
1000
4
34mm 89mm 34mm
The declaration of conformity is available on request. Contact details are provided at: http://paxton.info/596
Electrical shock can cause injury or death. Remove all power before making any electrical connections,
performing maintenance or repair.
Mains electrical connections should be made only by qualified personel in accordance with local regulations.
1. Safety goggles should be worn while using power tools.
2. Before drilling the mounting holes, check the area for concealed wires and pipes.
3. The power supply provided is suitable for internal mounting only.
Important information
To delete a card pack
1. Card packs may be deleted from the system if required. Once a card pack has been deleted another one may
be enrolled in its place.
2. To delete a card pack, take the master card and swipe it backwards through the reader. The LEDs should then
start to flash in sequence, one after the other.
3. During this phase, swipe the master card backwards again and the reader will beep once and the LEDs will all
come back on.
4. The card pack will now have been removed from the system
Voltage
Maximum load output current
Reader head life
Specifications
Electrical
Environment
Dimensions
Min Max
Width Height Depth
Current
Operating temperature
Cable length
Reader
IP Rating Outdoor Use
Swipes
Number of Cards
Number of Card Packs
Magnetic stripe coercivity
Min Max