Paxton PROXIMITY marine reader - Manual

25/01/2010
Fitting
Fix the backplate to the wall with the stainless steel screws provided in the fitting kit. The small slot in the plate
edge should be positioned at the bottom.
Where the unit is to be fitted to a smooth surface, bulkhead, etc. a gasket is supplied to provide a weatherproof
seal between the backplate and the mounting surface. (The unit has its own integral seal)
Locate the unit in the keyhole slots provided in the backplate. Make sure that the locking pin is close to the slot in
the edge of the backplate. Rotate the unit clockwise until the locking pin engages in the slot.
To remove the unit, insert a small screwdriver into the cut out provided and use it to lift the locking pin.
The unit can then be rotated anticlockwise to release it from the backplate.
Ins-30045 PROXIMITY marine reader
Technical Support
Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)
Saturday from 09:00 - 13:00 (GMT)
01273 811011 [email protected]
Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/
Paxton