Paxton Net2 Evaluation Kit - Manual (Page 3)

Software configuration
Run the Net2 software.
Check that the ACU has been detected by looking in the Doors screen. The firmware in the ACU’s will be
automatically updated to the same revision as the PC. Do not make any changes to the software during this phase.
Reader 1: Settings for Reader 1 and Keypad 1 on the ACU.
Reader 2: Settings for Reader 2 and Keypad 2 on the ACU.
Alarm: Contains settings for the different types of alarm.
Codes: Valid codes can be viewed, added and removed.
(Can only be viewed when a keypad is active).
Events: Shows the events for the control unit selected.
Door name: Name the ACU.
Door open time: Set the door open time.
Unlock the Door during: Permanently unlocks the door while
this timezone is active. - Should be set to ‘At No Time’ for
normal user operation.
Name: Each reader can be named individually if required.
Reader type: Set the reader type, if applicable.
Keypad type: Set the keypad type, if applicable.
Token data format: Select the data type being used on the
system. (New formats can be created).
Reader operating mode: Set the operating mode.
Timed operating modes: A different operating mode can be
configured within a time window.
Reader action: Set the action required when access is granted.
The following screen shows the setup for an ACU. This unit only requires Reader 1 to be configured to operate.
10,000
10,000
250
64
2,000
999,999 secs
50
1
2
2
2
200
50
9 hours
2,454
http://paxton.info/720
Number of PIN’s
Access Levels
Time Zones
Individual time periods per zone
Maximum door open time
Doors per ACU
Reader ports per ACU
Readers per port
Keypads per port
ACU per data line
Data lines per PC
Data retention after total power loss
Events stored in ACU with no server connection
Minimum Requirements
Hardware
Software
Specifications
Number of Cards
PC Installation
Number of Codes