Paxton Hands free demonstration unit User Manual
Page 2

Page 2
Q
The system comprises of a standard P50 proximity reader and a hands free interface.
1. Power up.
Q
Power up the unit and the reader LED’s will cycle through while the unit configures itself.
Q
All 3 LED’s will now be lit.
Q
This unit has been loaded with modified software to demonstrate the wireless range and flexibility of
Q
the Net2Air Hands free system. The reader will respond to a token with a beep and a flashing Green
Q
LED as soon as a valid read is achieved.
2. Presenting passive tokens.
Q
A range of standard Net2 tokens is included for comparison tests. Present any Paxton or EM4100 token
Q
to the reader. The reader will beep at the normal passive read range.
3. The keycard.
Q
A hands free keycard is provided. This card can be used in three ways:
Q
i. Passive - The keycard contains an ID chip that any P series unit can read up to 80 mm.
Q
ii. Active - The keycard has a hands free transmitter/receiver that will operate up to 1100 mm.
Q
Bring the keycard into range and the unit will respond using the hands free interface.
Q
The keycard must be then taken out of range again before a second read can take place.
Q
iii. Manual - The keycard transmitter can be activated from button 1. (Left). Pressing this button will
Q
produce a response up to 50 metres from the reader. Button 2 in not active on this card.
Q
The push button on the stand is not active with this demonstration system.
Operation