Paxton Net2 PaxLock - Scandic - Manual (Page 5)

Page 5
Net2 has NO PaxLock detection function. It is recognised that there could be security issues if the
wireless units were detectable from outside the site. During installation, a PaxLock unit binds to a Net2Air
bridge which will then only talk to registered units.
Devices cannot be added to the system if commissioning mode is disabled.
An entry is then made on the Doors screen and a special icon is used to denote the wireless connection.
Presenting a valid user token to the unit will cause the LED to briefly flash green and the door will unlock.
The presentation of a barred or unknown user token is indicted by a red LED display.
The external handle is only engaged once access has been granted. The inside handle is always engaged.
Normal operation
Software configuration
Reader: Local settings for the reader.
Output: Configures the lock for timed release or toggle mode.
Alarm: Enables/Disables the door alarm functions.
(requires contact switch)
Events: Shows the events for this control unit only.
Access rights: Lists users who have access through this door.
Door name: name the door.
Door open time: Set the door open time.
Unlock the door during: Holds the door unlocked during this
timezone. - Set to 'at no time' for normal user operation.
Red flash
Red and Green flash together
A valid user card has been presented and the handle is engaged
An invalid user card has been presented - No access granted
LED indications
Green flash
The unit is configuring - Please wait. Red and Green flash alternately
The unit is not bound to a bridge.