Paxton Net2 PaxLock - Scandic - Manual (Page 2)

Page 2
The lock case and cylinder (not supplied) must first be
fitted to the door, ensuring that a 24 mm diameter hole
is drilled for the follower (as shown on the template
provided).
Slide the spindle through the lock to allow the template to
locate over it. Ensure that the template is square to the
door edge by using the top and bottom ruler scales.
Mark the 2 x 10 mm, 1 x 16 mm holes. Remove the
template and repeat the procedure for the other side.
Step 1 - Marking out
Step 2 - Drilling
Remove the lock if required and drill the 2 x 10 mm holes
for the mounting screws and 1 x 16 mm hole for the
wiring harness.
To ensure accuracy you should drill these holes from both
sides of the door towards the centre. This also avoids
the risk of damaging the door face when the drill breaks
through.
Place the thumb turn follower against the lock casing
making sure to position it in line with the two holes within
the casing.
Thread two mounting screws through the follower and the
lock casing till it reaches the key lock (sold separately) on
the opposite side.
Tighten the screws until the key lock is held securely.
Step 3 - Contact switch (optional)
If a contact switch is to be fitted an additional hole is
required in the edge of the door.
Drill a hole of the required size to receive the switch
assembly. This should intersect the 16 mm hole drilled
previously to take the wiring harness.
Feed the contact wires through the door to exit on the
inside.
Step 5 - Fitting the lock
Ш 16
37
211
Ш 10
Pax
ton
70 60 50 40 30 10 5 5 15 15 0 20 25 25 35 35 45 55 65 75 45 55 65 75 10 20 30 40 60 70 50
The spindle is locked into the front lock assembly by
means of a spring loaded pin.
Ensure that the spindle pin and the hole in the square
drive are in alignment before depressing the pin and
sliding the bar into the assembly. The pin will then latch
into the hole securing the spindle in place.
Step 4 - Attach the spindle