Pavement Ends 51203 Replay - Manual (Page 7)

51203 pg 7 0612 Rev. A
Rear Window -
Backing Side
Tailgate Bar
Tailgate
Retainer
Channel
Tubed
Strip
Step Twenty-two
I
NSTALL
E
LASTIC
G
ARTERS
Snap the Elastic Garters to the
snaps on the Rear Bow above
the rear window opening.
Tuck Flaps
under top
Pull both sliders down as far
as possible to catch pin
Start
Zipper
Snap Elastic Garters
to Rear Bow
Step Twenty-three
I
NSTALL
T
AILGATE
B
AR ON
R
EAR
W
INDOW
Remove the Rear Window from the box and lay it fl at with the
backing side up. Locate the Tailgate Bar set aside in Step One.
The bar has a “C” shaped channel, when viewed from the
end. Orient the bar with the round seal down and slide the “C”
channel on the retainer onto the tubed strip sewn to the backing
side of the Rear Window.
Step Twenty-four
I
NSTALL
T
AILGATE
B
AR ON
V
EHICLE
Insert the Tailgate Bar into the mounts on
each side of the tailgate opening with the
vinyl side of the Rear Window toward the
outside of the vehicle.
Place Tailgate
Bar in mounts
Step Twenty-fi ve
S
ECURE
R
EAR
W
INDOW
Z
IPPERS
To start the zipper, pull the two sliders as far down as possible on the
driver’s side of the window in order to catch the sliders to the pin.
Once the zipper is caught, start the top slider 1/2". Then hold up the
top of the window with one hand and close the zipper with the other.
The zipper is sandwiched between layers of fabric in the corners so be
careful not to catch extra fabric in the zipper. Close the zipper.
Make sure that the Tailgate Bar is centered and is securely in the
mounts. Then tuck the fl aps on the Rear Window under the top fabric.