Pavement Ends 51131 Replay - Manual (Page 8)

51131 pg 8 Rev. C 0204
Installing the New Door Covers
Note: For the best results and to minimize
scratches on the windows, remove all jewelry
before installing the door covers.
1. Install Lower
Rear Corner
3. Install Upper
Front Corner
Unzip Window
before installing
Hook and
Loop
Note: This door cover is designed to fit very tight on the
door frame. We recommend using a shoe horn to help
work the corners of the cover over the frame without
tearing the fabric.
WARNING
Do not pull on the weatherstrip to assist in getting the door cover
on the door frame. This will tear the weatherstrip and the door
will not seal properly.
4. Use tab to install
Upper Rear Corner
2. Install Lower
Front Corner
Weatherstrip
Detail of Hook and Loop - Lower
Front Corner
Pull Flap Up
First
Hook and
Loop
Detail of Hook and Loop -
Top of Door
Door Frame Between Hook
and Loop Flaps
Step Fifteen
Remove the fabric upper doors from the vehicle. Use a
razor knife to cut the stitches on the old door covers and
take them off of the door frames.
Step Sixteen
Unzip the windows and separate the hook and
loop fasteners on the door covers. Lay the door
cover on a flat smooth surface with the outside
facing down.
Start by working the lower rear corner of the door
frame into the pocket in the lower rear corner of
the cover. Then work the lower front corner of the
frame into the cover. Work the top front corner of
the frame into the corner of the cover, between
the hook and loop flaps (not between the zipper
and the flap). Finally, use the tab sewn into the
cover to work the last corner of the frame into the
corner of the door cover, again between the hook
and loop flaps.
Make sure that the top edge of the door cover is
straight along the top of the door frame. Work
around the door fastening the hook and loop
strips tightly around the door frame. Once the
door cover is on the frame, the tab in the top rear
corner of the cover may be cut off with a pair of
scissors if desired.
Step Seventeen
Reinstall the upper doors. Insert the
pins into the grommets in the lower
door.