Pavement Ends 51131 Replay - Manual (Page 7)

51131 pg 7 Rev. C 0204
Rear Window -
Backing Side
Step Twelve
Remove the Rear Window from the box and lay it flat with the backing side
up. Locate the Tailgate Bar set aside in Step One. The bar has a "C" shaped
channel, when viewed from the end. Orient the bar with the round seal down
and slide the "C" channel on the retainer onto the tubed strip sewn to the
backing side of the Rear Window.
Tailgate Retainer
Tailgate Retainer
Channel
Tubed Strip
Step Thirteen
Insert the Tailgate Bar into the mounts on each side of
the tailgate opening with the vinyl side of the Rear
Window toward the outside of the vehicle.
Place Tailgate Bar in
mounts
Pull both sliders down as
far as possible to catch
pin
Start Zipper
Tuck Flaps
under top
Step Fourteen
To start the zipper, pull the two sliders as far down as possible on the
driver's side of the window in order to catch the sliders to the pin.
Once the zipper is caught, start the top slider 1/2". Then hold up the top
of the window with one hand and close the zipper with the other. The
zipper is sandwiched between layers of fabric in the corners so be careful
not to catch extra fabric in the zipper. Close the zipper.
Make sure that the Tailgate Bar is centered and is securely in the mounts.
Then tuck the flaps on the Rear Window under the top fabric.