Pavement Ends 51131 Replay - Manual (Page 5)

51131 pg 5 Rev. C 0204
Step Four
Raise the header and bow assembly
toward the windshield and into
position.
Inside the top, snap the fabric to
the Rear Bow (six snaps).
Snap fabric to
Rear Bow
Step Five
Close the header latches to secure the front of the top to
the windshield. Catch the hook in the slot in the windshield
frame and then close the lever over it so that it lays flat
against the windshield frame.
Windshield
Frame
Header Latch
Catch hook
in slot
Close lever over top
of hook to lay flush
with windshield frame
Step Six
Make sure that the Center Bow is centered in the hook and
loop flap inside the top. Do not fasten the flap at this time.
Pull down gently on the Rear Bow and work the plastic
sewn to the rear corners of the top into the retainer on the
vehicle.
Pull down gently on the
Rear Bow and slip plastic
into retainer
Windshield
Step Seven
Wrap and fasten the hook and loop on the
two flaps inside the top around the Center
Bow.
Wrap flaps around bow and
fasten hook and loop
View from inside vehicle
Sport Bar
Center Bow