Pavement Ends 44527 Flip Top - Manual (Page 5)

Rev. H 1210 44527 pg 5
Step Four
A SSMEBLE B OW A SSEMBLY
Assemble the two halves of the support bow. Orient the two pieces to each other and lay them on the fl oor. Slide the pieces to-
gether, pushing down on the buttons. Once the two halves are together install a Snap Head Screw in the hole formed in the center,
front of each bow. This will require a #20 TORX socket.
Front Bow
Rear Bow
Foam
Foam
Slide Bow
Halves Together Push buttons in
Slide halves together to form
Support Bow Assembly
Note: It may be helpful to use a fl at screwdriver to push buttons down while sliding bow halves together.
Slide Bow Ends
into Track
Front Bow
Rear Bow
Inside of Vehicle
Side Belt Rail
Note: It may be helpful to have two people to slide both sides of the
bow assembly forward at the same time.
Step Five
I NSTALL B OW A SSEMBLY
Slide the ends of the front and rear bows into the tracks in the Side
Belt Rails on each side of the vehicle. Start from the rear of the vehicle
and slide the bow assembly toward the front.