Multiquip DCA180SSIU - Manual (Page 33)

DCa180SSI/DCa180SSIu 60 hz gen/ • operaTIon anD parTS manual — rev. #1 (08/02/10) — page 33
of the battery fluid is 1.28 (at 68° F). If the specific gravity
should fall to 1.245 or lower, it indicates that the battery is
dead and needs to be recharged or replaced.
Before charging the battery with an external electric source,
be sure to disconnect the battery cables.
Battery Cable Installation
alWaYS be sure the battery cables (Figure 35) are
properly connected to the battery terminals as shown below.
The red cable is connected to the positive terminal of the
battery, and the black cable is connected to the negative
terminal of the battery.
Figure 35. Battery Connections
When connecting battery do the following:
1.
never connect the battery cables to the battery
terminals when the mpeC Control Switch is in either
the manual position. alWaYS make sure that the
mpeC Control Switch is in the oFF/reSeT position
when connecting the battery.
2. Place a small amount of battery terminal treatment
compound around both battery terminals. This will
ensure a good connection and will help prevent
corrosion around the battery terminals.
CauTIon
alWaYS disconnect the negative terminal FIrST and
reconnect negative terminal laST.
NOTICE
If the battery cable is connected incorrectly, electrical
damage to the generator will occur. Pay close attention to
the polarity of the battery when connecting the battery.
CauTIon
Inadequate battery connections may cause poor
starting of the generator, and create other malfunctions.
alTernaTor
The polarity of the alternator is negative grounding type.
When an inverted circuit connection takes place, the
circuit will be in short circuit instantaneously resulting the
alternator failure.
Do noT put water directly on the alternator. Entry of water
into the alternator can cause corrosion and damage the
alternator.
WIrIng
Inspect the entire generator for bad or worn electrical wiring
or connections. If any wiring or connections are exposed
(insulation missing) replace wiring immediately.
pIpIng anD hoSe ConneCTIon
Inspect all piping, oil hose, and fuel hose connections for
wear and tightness. Tighten all hose clamps and check
hoses for leaks.
If any hose (
fuel or oil) lines are defective replace them
immediately.
inspectiOn/setUp