Generator outputs/gauge reading – Multiquip DCA180SSIU User Manual
Page 27
DCa180SSI/DCa180SSIu 60 hz gen/ • operaTIon anD parTS manual — rev. #1 (08/02/10) — page 27
generatOr OUtpUts/gaUge reaDing
Figure 14. Voltage Change-Over Board
3Ø 240V Configuration
aC voltmeter gauge reading
Place the
AC Voltmeter Change-Over Switch (Figure 15)
in the W-U position and observe the phase to phase voltage
reading between the W and U terminals as indicated on
the
AC Voltmeter Gauge (Figure 16)
Figure 15. aC voltmeter Change-over Switch
Figure 16. aC voltmeter gauge
aC ammeter gauge reading
Place the
AC AmmeterChange-Over Switch (Figure 17)
to the U position and observe the current reading (load
drain) at the U terminal as indicated on the AC Ammeter
Gauge (Figure 18). This process can be repeated for
terminals V and W.
Figure 17. aC ammeter
Change-over Switch
Figure 18. aC ammeter
(amp reading on u lug)
NOTICE
The
ammeter gauge will only show a reading when
the
Output Terminal Lugs are connected to a load
and in use.