Multiquip DCA150SSK2 User Manual

Page 47

DCA-150SSKII — PARTS AND OPERATION MANUAL— REV. #1 (05/08/01) — PAGE 47

WARNING:

Before Starting

Engine

1. Check the lubricating oil level prior to starting the engine.

Make sure the generator is level. The oil level must be
maintained between two notches on the dipstick.

2. When there is not enough lubricating oil, fill the crankcase

with high grade motor oil. Use a high quality detergent
oil classified CC or higher (See Table 12 on page 43).

3. Check the coolant level in the radiator and subtank.

Replenish with antifreeze as necessary. Always maintain
the coolant level between the FULL and LOW markings
on the coolant container. Be sure that the radiator cap is
fastened securely.

4. Check the fuel level on the fuel gauge. If fuel is low, fill

the fuel tank with clean fresh unleaded automotive diesel.
If diesel spillage occurs, completely wipe up the spilled
fuel immediately.

Before Starting

Generator and Control Panel

CAUTION:

1. Be sure to disconnect the electrical load and switch the

main, load and G.F.C.I. circuit breakers (Figure 42) to
the “OFF” position prior to starting the engine.

NEVER start the engine with the
main, GFCI or load circuit
breakers in the ON position.

The engine's exhaust contains
harmful emissions.

ALWAYS ventilate

the exhaust when operating inside
tunnels, excavations or buildings.
Direct exhaust away from nearby

Figure 42. Main, GFCI and

Load Circuit Breakers

DCA-150SSKII — GENERATOR START-UP PROCEDURE (MANUAL)

2. Once it is determined if commercial power is required,

connect the load to the UNV terminals as shown in
Figure 43. These terminals can be found on the output
terminal panel, see page 33, Figure 14. To gain access
to the output terminals lift the UNV cover. Make sure to
tighten terminal nuts securely to prevent load wires from
slipping out.

Figure 43. UNV Terminal Lugs (Load)

NEGA

TIVE

POSTIVE

BATTER

3. Connect the negative battery cable (BLACK) to the

negative post on the battery (Figure 44).

Figure 44. Battery Connections

Table of Contents