Multiquip HHN34TVD - Manual (Page 21)

HHN34TVD RIDe-ON TROWeL • OpeRaTION maNuaL — ReV. #2 (01/10/11) — page 21
baSic enGine
Figure 5. Diesel Engine Components
INITIaL SeRVICINg
The diesel engine (Figure 5) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to the
manufacturer’s engine manual for instructions and details
of operation and servicing. The engine shown above is a
Briggs & Stratton Vanguard Diesel engine. Operation for
other types of engines may vary somewhat.
1.
engine Tag — Provided engine model identification
and information.
2. muffler — Used to reduce noise and emissions.
3. Fuel Injectors — Provides diesel fuel mixture to
combustion chambers.
4. glow plug — Energizes to aid in cold starting.
5. Throttle lever — Controlled by accelerator pedal,
increases or decreases engine RPM.
6. Oil Drain plugs (2) — Remove to drain crankcase
oil. Always dispose of used oil and oil filters in an
WaRNINg
Engine components can generate extreme
heat. To prevent burns, DO NOT touch
these areas while the engine is running or
immediately after operating. NeVeR operate
the engine with the muffler removed.
environmentally safe manner. DO NOT allow used oil
to drain onto the ground or into a water runoff drain.
7. Fuel Filter — Filters fuel for contaminants.
8. Oil Filter — Spin-on type, filters oil for contaminants.
9. Oil Dip Stick — Remove to check amount and
condition of oil in crankcase.
10. Injector pump — Provides fuel to the fuel injectors.
11. air Filter — Prevents dirt and other debris from
entering the fuel system. Unsnap air filter cover to gain
access to filter element.
12. Thermostat — Regulates the temperature of the
engine coolant.
13. Oil Filler Cap — Remove to add engine oil.
14. Starter — Starts engine when ignition key is rotated
to the "ON" position.
15. alternator — Provides charge for battery and voltage
for the +12 VDC electrical system.
16. Oil pan — Holds a maximum of 3.5 quarts (3.3 liters)
of motor oil.