Wrs-5200 — machine start-up and operation – Multiquip WRS5200 User Manual
Page 25

WRS 5200 RIDE-ON ROLLER SCREED — PARTS MANUAL— REV. 1# (08/09/02) — PAGE 25
WRS-5200 — MACHINE START-UP AND OPERATION
WARNING!
PETROLEUM PRODUCTS ARE FLAMMABLE.
Never fill the gas tank while the engine is running or hot.
Petroleum products can cause damage to the environment
so spills should be cleaned up immediately.
C.
MAINTENANCE
Note: See the engine manual supplied with your machine
for appropriate engine maintenance schedules and trouble-
shooting guide for problems.
There is a “Daily Preparation Checklist” in the front section
of this manual. Please feel free to make copies of it and use
it on a daily basis.
WARNING!
D.
MAINTENANCE SCHEDULE
Daily (8-10 Hours)
⇒ Check the fluid levels in the engine and hydraulic re-
serve , fill as necessary.
⇒ Lubricate all grease zerks after cleaning the machine
while the chain guards are off, including bearings on the
middle brackets which hold the splined shafts.
Weekly (30-40 Hours)
⇒ Check and clean or replace the engine air filter as nec-
essary.
⇒ Replace the engine oil and filter as necessary, see en-
gine manual.
⇒ Check bolts for tightness on truss sections.
Monthly (100-125 Hours)
⇒ Check air pressure in tires.
Yearly (500-600 Hours)
⇒ Replace hydraulic fluid and filters.
⇒ Check set screws on the middle bracket bearings which
hold the splined shaft in place. If loose, add some liquid
locking agent to the set screws and re-tighten. A “stop”
inside the strike tube prevents the splined shafts from
ever moving too far.
⇒ Note: After the first 100 hours, replace the hydraulic
filter cartridges.
DISCONNECT BATTERY CABLES AND
SPARK PLUG WIRES BEFORE ATTEMPT-
ING ANY SERVICE OR MAINTENANCE ON
THIS MACHINE.