MTS Criterion 40 - Lifting and Moving Instructions - Manual (Page 15)

Moving C43 (30 kN, 50 kN) and C44 Frames
MTS Criterion
®
Series 40 Lifting and Moving Instructions
15
To right a package from a prone position:
1. Using a forklift, approach the frame from the light end of the package.
2. Insert the forks under the shipping skid.
3. Lift the whole assembly to about a 35° angle relative to the floor.
4. Wind the safety line or safety belt between the package and forklift carriage
to prevent the package from overturning suddenly.
5. Move the forklift carriage up and forward slowly until the package stands on
its base in an upright position.
When the package is upright, proceed with the unpacking and installation
process.
Transporting
procedures
There are three methods for transporting the load frame to the test site:
• Frame Base method—use a forklift to lift the upright load frame from
underneath the base with the shipping skid still attached.
• Crosshead method—use a forklift with padded forks to lift the load frame
from under the crosshead.
• Crane method—use a crane to lift the upright load frame from the
crosshead. If this method is used, MTS recommends using professional
riggers experienced in moving heavy equipment.
Frame base method
To transport the load frame using the frame base method:
1. Ensure that the frame is bolted to the shipping skid.
2. Carefully insert the forks under the shipping skid.
3. The crosshead should be in its lowest position so that the frame is not top
heavy.
The frame may overturn suddenly when lifting the frame.
An overturned frame can cause injury or death to anyone in the immediate
area.
Ensure that all persons in the immediate area are standing away from the
frame during lifting. Do not lift the frame more than 8 cm (3 in) off the floor.
4. Slowly and carefully lift the frame off the floor.
5. Move the frame to its operating location.
6. Slowly lower the frame to the floor.
WARNING