Aligning the force transducer, Required equipment – MTS Landmark Floor Standing User Manual
Page 91

Torque
Load Unit
190 N·m (140 lbf·ft)
370.10
271 N·m (200 lbf·ft)
370.25
271 N·m (200 lbf·ft)
370.50
7. Repeat Steps 4 and 5 until all the bolts have been lubricated.
Aligning the Force Transducer
This section describes how to align a force transducer with the load unit actuator. The load units shown may
vary from what you may have.
The Model 370.10 and some 370.25 Load Units come with two types of transducer mounting hardware. One
preloads the force transducer with a hex nut; the other uses a preloader collar with jackbolts or captive set
screws.
The Model 370.50 and some 370.25 Load Units use a preloader collar with six or eight internal jackbolts to
preload the force transducer.
Required Equipment
•
Torque wrench with a 5–135 N·m (5–100 lbf·ft) range
•
Molykote G·n paste
•
Rubber mallet
•
0.0025 mm (0.0001 in) precision dial indicator with a magnetic base
MTS Landmark™ Floor Standing Load Units Product Information 91
Maintenance