MTS Acumen Electrodynamic Test Area Enclosure - Manual (Page 12)

4. Put M5 C'Bore butt fasteners (item 9) in the two bottom slots in the side panel and insert the DIN912 M5
x 0.80 mm x 30 mm SST sockethead cap screws (item 8).
5. Position the side panel (item 6) on the frame such that the bottom screws fit through the foot mounts and
into the threaded holes.
6. Take the screw from step 3 and secure the top bracket (item 3) to the frame. Hand-tighten.
7. Hand-tighten the screws securing the side panel to the frame base.
8. Repeat steps 2 through 7 for the other side panel.
9. Using the supplied Allen wrench, snug down all fasteners. Do not over-tighten.
Fasteners should be tightened enough to hold the panels firmly in place but not so tight the panels cannot
be slightly positioned for alignment after the back panel (item 1) and front door (item 12) are installed.
10. Place the front door into position and secure the top hinge to the side panel using one M6 x 1.00 mm x
12 mm buttonhead cap screw (item 5).
11. Close and latch the door to hold it in place.
12. Install the remaining three M6 x 1.00 mm x 12 mm buttonhead cap screws. Tighten enough to hold the
door firmly in place, but not so tight the door cannot be slightly positioned for alignment after the back
panel is installed.
13. Remove the four (4) M6 buttonhead cap screws and washers (items 1 and 2) and safety switch (item 3)
from the door assembly and right side panel and set aside.
14. With the door lightly secured to the left side panel, remove four (4) M6 flathead screws (item 4) that are
securing the upper and lower hinges to the left side panel assembly. Remove the door assembly and set
aside.
15. Remove the two (2) M3 buttonhead screws (item 5) and two (2) bumpers (item 6) from the right side panel
assembly.
16. Remount the bumpers to the left side panel assembly.
17. Remove two (2) M4 flathead screws (item 7) and tension catch (item 8) from the right side panel assembly
and remount in the left side panel assembly.
18. Rotate the door assembly 180 degrees and remount to the right side panel assembly.
19. Remount the safety switch (item 3) to the left side panel assembly with the sensor cable in an upward
direction.
12 MTS Acumen™ Electrodynamic Test System
Test Area Enclosure Installation