MTS Hydraulic Power Unit Model 506-92 - Manual (Page 32)

Installation 4-1
Section 4
Installation
Introduction This section provides the following installation information for the Model
506.82/.92 Hydraulic Power Unit (HPU).
• hydraulic connections
• electrical connections
• water connections
Before you
complete
connections Perform these steps before you make any connections to the HPU.
1. Remove the shipping plate located under the hydraulic fluid filler
cap.
2. Make sure that the chained jumper plug is connected to the remote
control connector located on the side of the starter box door. See the
figure below.
remote control
connector
starter box
door
VW-G045B
Figure 4-1. Location of Remote Control Connector
For remote control
connection The jumper plug may be replaced by the system cable from a remote
control device when the HPU is ready for system operation.