MTS Hydraulic Power Unit Model 506-92 - Manual (Page 30)

3-18 Service
Table 3-3. Fixed Controller Output Indicators
Output Indicator Ch0 Description
0 Turns on to energize pump motor 1 start control relay CR1.
1 Turns on to energize pump motor 1 run control relay CR2.
2 Turns on to energize pump motor 2 start control relay CR3.
3 Turns on to energize pump motor 2 run control relay CR4.
4 Turns on to energize pump motor 1 high- pressure solenoid SOL1.
5 Turns on to energize pump motor 2 high- pressure solenoid SOL2.
6 Turns on to energize main high- pressure solenoid SOL3.
7 Turns on to energize water inlet solenoid SOL4 that allows water flow into
the heat exchanger for cooling hydraulic fluid.
8 Turns on to light front panel Over Temperature indicator.
9 Turns on to light front panel Low Oil Level indicator.
10 Turns on to light front panel Overload indicator.
11 Turns on to light front panel Dirty Filter indicator.
12 Turns on to light indicator on Pump 1 Select switch.
13 Turns on to light indicator on Pump 2 Select switch.
14 Turns on to light indicator on Local Mode switch.
15 Turns on to energize supercharge pump control relay CR5.
Table 3-4 Fixed Controller Input Indicators
Input Indicator Ch0 Description
0 Spare
1 Spare
2 Turns on momentarily if the Start switch is pressed.
3 Turns on momentarily when Stop switch is pressed. This momentary “high”
will shut off the pump it is running.
4 Turns on momentarily if the High Pressure switch is pressed
5 Turns on momentarily if the Local Mode switch is pressed.
6 Turns on momentarily if the Pump 1 Select switch is pressed.
7 Turns on momentarily if the Pump 2 Select switch is pressed.
8 Turns on if the front panel Reset switch is pressed.
9 Turns off if the E-Stop chain through the remote connector is not satisfied.
10 Spare