MK Diamond CX-3 User Manual

Page 9

• NEVER disconnect any “emergency or safety devices”. These devices are intended for

operator safety. Disconnection of these devices can cause severe injury, bodily harm or

even death! Disconnection of any of these devices will void all warranties.
• Unauthorized equipment modifications will void all warranties. Manufacturer does not

assume responsibility for any accident due to equipment modifications.
• NEVER use accessories or attachments, which are not recommended by MK Diamond for

this equipment. Damage to the equipment and/or injury to user may result.

WARNING

NOTE:

DO NOT use woodcutting, or carbide blades on this machine! Use ONLY Diamond blades on

machine. Use machine only to cut concrete and asphalt. DO NOT use machine to cut wood or

wood products.

Exhaust gas from gasoline engines contain dangerous carbon monoxide. Breathing it can cause

unconsciousness and even kill you. Always operate gasoline engine machines in a well-ventilated

area DO NOT operate in areas where exhaust fumes could accumulate without wearing appropriate

respiratory protection.

The operator must be aware of the machine’s capabilities and limitations. It is

the operators responsibility to use this machine under safe working conditions

and conform with federal, state and local codes or regulations pertaining to

safety, air, pollution, noise etc...

Prior to operation of this machine the operator must determine the existence

and location of any subsurface features that may be hazardous or could dam-

age the equipment, (i.e. electric cable, natural gas line etc.)

Before starting the machine, ALWAYS check that all guards are in position and correctly fitted. Check

the machine for loose bolts before starting.

Keep area around the machine clear of obstructions which could cause persons to fall onto moving parts.

ALWAYS ensure that the machine is on level ground before using. Know how to stop the machine

quickly in case of emergency. NEVER try to stop a moving blade with your hands.

CX-3

PRE-START

WARNING

Diamond Blades improperly used are dangerous. Comply with American National Standards Institute

Safety Code, B7.1 and, Occupational Safety and Health Act covering Speed, Safety Guards, Flanges,

Mounting Procedures, General Operating Rules, Handling, Storage and General Machine Conditions.