MK Diamond MK-5000 Gas - Manual (Page 21)

21
(D)
Continue Lowering Cutting Head
until cut is complete. Turn the
saw off when work is complete.
Cutting with the Cutting Head Positioned Down
This method is preferred when cutting small objects.
(A)
Lower the Cutting Head until the
blade is just off the surface of
the Movable Cutting Table.
(B)
Set masonry piece in position.
Start engine.
(C)
Open the Cooling Flow Control
Valve and adjust flow. Verify
proper cooling flow on
both sides of the blade.
(D)
Slowly push piece toward Blade
to cut. Allow Blade to stop before
removing work. Turn the saw off
when work is complete.
CaUTiON DO NOT FORCE TOOL, it will do the job better and safer at rate for which it
was designed.
MK-5000G OPeraTiON