MK Diamond MK-770 - Manual (Page 24)

MK-770 Revision 06/05, Effective Date June 17, 2005 Page 24
SETUP, ADJUSTMENT and OPERATION
5. Cleanup:
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of wastewater in accordance with applicable Federal, State and Local laws.
Ensure the saw is disconnected before completing the remainder of the cleanup process.
Slide Water Pan
out front of Saw
(D)
Ensure the ON/OFF Switch is
in the OFF position
(F)
Unplug MK-770 from the GFCI
(E)
Unplug the GFCI from the
Power source
(B)
Place the Water Pump in an
external container
(A)
Clean the Water Pump suction
of all debris
(C)
Run the MK-770 until clear water
is seen at the blade Cooling
Flow Points (Approx. 1 minute)
(H)
Remove the Water Pan from
the MK-770
(I)
Clean the Water Pan
(G)
Clean the MK-770 with soap
and clean water
Clean Water
Pan
Unplug
Soap and
Fresh Water
Cooling Flow
Points
Water Pump
In container
External
Container
GFCI ON/OFF
Switch
Off Position
Pump
Suction